Generally, the extended use of a high-temperature fan c […]
Generally, the extended use of a high-temperature fan causes deformation of the main shaft, and therefore, measures to prevent deformation during use of the high-temperature fan are as follows.
When the fan is not stopping, it can rotate the propeller of the aerosol fan and appropriately extend the exhaust speed at the tail, thereby increasing the negative pressure at the fan inlet at a very low temperature.
The central operating instructions are determined through standard operations, and the technical parameters are strictly limited. They are used to measure the exhaust volume and pressure adjustment deformation at the entrance of the C-1 pipe of the Keelung heat exchanger. When the exhaust gas measurement at the inlet of the C-1 pipe is less than 430°C, strictly control the negative gas of the high-temperature centrifugal fan.
When the live recording at the main site is not activated and can be activated immediately, set the auxiliary transmission of the high temperature fan. The low-temperature fan slides at low temperatures to ensure uniform heating of the main optical axis.
A failure contingency plan is needed to ensure safe use of power outages. Add a combustion gas temperature sensor at the inlet of the high temperature fan. After closing, the inspection door of the C1 cylinder must be opened, forced cooling must be stopped, and inspections must be carried out at the same time.